Balterboy's
Pumping Technique
Here's a typical
routine for a long cock and ball pump session.
I'm using two tubes,
2" and 2.5" diameter and three jars, with roughly 3.75",
4.5"
and 5.25" wide mouths. (I tend to go for girth rather than length
because,
lets face it, I'm not gonna set any records in that category.)
For a couple hours
before, I'll drink several glasses of water, then take a healthy piss
before I begin. I start out in the 2" tube, for only 15 - 20 minutes
to 'fluff up'.
After a 2-3 minute
break, I go into the first jar for 30-40 minutes.
Most of the expansion takes place after about 25 minutes; if I go
as long as 45 minutes, getting through the 3.75" wide mouth can
be difficult.
Another short break,
then I go back to the 2" tube, and pack it
solid in about 20-30 minutes. After a couple minutes, I move on to the
next
jar and go 45 minutes - getting out of 4.5" width will take a couple
minutes.
Then I move onto
the 2.5" tube. I'm
in it for about 25 minutes. My
donut and about a third of my length will pack, but not so much around
the
base, and I don't want to push it and put too much pressure on the head
at
this point.
By the time I start
on the third jar my balls are about 15" around,
so from here on out its a matter of how much longer I can take it
before the glass starts seriously chafing my skin.
My longest session
ran a little over 3.5 hours, where I maxxed out
at a sac just
under 16.5" around.
At that size getting out of that last jar took about 10 minutes with
lots
of lubrication. But the results were not wasted...