Penis Pumping Q & A Archive

By Tiger, Pumper

Last updated August 15, 2001

I'm trying to get more length than girth now...

I have a 2x9 a 2.5 x 10 and a 3x10 straight wall that I put my cock and balls into together.

Can you recommend a batting order for using them and maybe a time frame for each?

- Blown Away

I've been working on the length issue myself and here's what works best for me. Still a work in progress, so I'd appreciate your feedback and experience with these techniques.

As we all know, getting length depends on inducing the suspensory ligament to relax. (This is the ligament that holds your cock to your body.)

You can get an inch of pumped up length just by filling the cavernosa and stretching the cockshaft, but to get 2 or 3 inches you gotta stretch that ligament! In my experience, the ligament takes about an hour of pumping to relax - longer for a beginner.

You definitely know when it relaxes, because you get a real nice pumped feeling behind your balls - I call it the pumper's high, that's how good it feels for me. I've found that my ligament will relax whether I'm packed or not, so the tube size doesn't matter for that.

When you pack, all the vacuum pressure is on the head, so you run the risk of petechia or bruising the glans. Packing feels so good that you want to increase the pressure, but you have to be real careful. I've had a few problems with "red head" and it takes weeks to cure. I bring this up because, to really stretch the ligament once it relaxes, you gotta pack. It's the only way I know to direct all the suction force down the shaft of the penis and coax the ligament.

So my techniques for stretching all involve getting the most ligament action with the least pressure.

Here's what I do.

Once my ligament has relaxed, I pack a narrow tube, which I can do quickly with little pressure. You want the cylinder to grip the entire shaft like a sleeve, so make sure you pack fully. Keeping the pressure light, I slowly milk the tube, about 1 stroke every 3 - 4 seconds. For some reason, the action of pressing in seems to do more of the work than the pulling out. So I push in slowly, hold it for about a second, then pull out slowly.

When milking, I vary the direction of the out-stroke, usually pulling downward, but sometimes sideways or upward. The ligament gets looser when stretched at different angles.

When not milking, I hang the tube downward, for a gravity assist. This works best when waterpumping - you can really feel the weight of that water.

Here's where tube size matters - the longer the cylinder, the more water you can put in. I also like to walk around with the tube just hangin. Again, the random movements help the ligament relax and stretch more.

These stretching sets are longer than regular sets - I usually go about 30 minutes. As with any set, you raise the pressure toward the end, but be real careful - pay close attention for any discomfort in the cockhead. I usually quit while it still feels real good. I end the set with a minute at low pressure and the tube hanging straight down, and then a short stint at higher pressure to stretch the cock out fully.

Often I repeat this cycle a couple times. Very relaxing.

During breaks, I milk as usual (the twisting pull method, not the long shaft pull). I also swing my cock gently, to put more action on the ligament. Don't swing too hard - I've found that causes the ligament to tighten defensively. I also make a V with my fingers above the cock and push down gently and rhythmically. And I massage the groin to relax myself.

With each set, I lengthen about 1/2 inch.

After the break, I go back into the same tube and re-pack it. If the tube feels too tight after a couple minutes, I switch to a fatter tube. Otherwise I just carry on.

Don't be surprised if you start the new set kinda short and don't stretch out right away. The ligament often tightens up temporarily and has to be coaxed to relax again. As with any stretch, you need to repeatedly relax and stretch the ligament. And you need to gradually increase the force - the vacuum pressure. By carefully managing the pressure, I can do 4 - 6 sets and stretch out 2 - 3 inches.

After the pump, I walk around and let my member swing, to keep the ligament loose.

Over time, the ligament adapts to being pumped and gets generally looser. It relaxes and stretches quicker.

Between pumps, I've found that I can get it to relax some by making the V over my cock and swinging it. This gets me to my max flaccid length real quick, and gives me about 1/2 - 1 inch of extra length when I harden up. Maybe someday I'll get 2!

A couple suggestions for equipment to help you stretch faster. I like to use thickwalled tubes. They grip the base of the penis better, and dig into the groin so as to focus the stretching force straight into the ligament. I have a CTC electric pump that gives "suck-release" action. This makes the ligament relax quicker. You can get much the same effect by varying the pressure on a manual or constant suck pump. Suck-release by itself doesn't seem to produce more of stretch - you still have to pack. But once you go pack, it helps to keep the ligament relaxed.

Try these techniques and let me know how they work, or how you improve em!

Good luck bud,

- Tiger